rprt.net
当前位置:首页 >> 模具英语专业术语.DoC >>

模具英语专业术语.DoC

Designer - 设计师. Assembly drawing - 模具组装图. Mold layout - 模具结构图.2D product drawing - 2D产品图.3D product data - 3D产品数据.Part drawing - 散件图. Insert molding - 镶件模.2 color mold / Double injection tool - 双色模. Hydraulic system - 油/水压系统. Parting line - 分模线.

模具述语一、入水:gate进入位:gate location水口形式:gate type大水口:edge gate细水口:pin-point gate水口大小:gate size转水口:switching runner/gate唧嘴口径:sprue diameter二、流道:runner热流道:hot

die 模具 figure file, chart file图档 cutting die, blanking die冲裁模 progressive die, follow (-on)die 连续模 compound die复合模 punched hole冲孔 panel board镶块 to cutedges=side cut=side scrap切边 to bending折弯 to pull, to stretch拉伸 Line

朋友,通常模具用mold或者mould, 工具常用作tool.希望能够帮到你.

die 模具 figure file, chart file图档 cutting die, blanking die冲裁模 progressive die, follow (-on)die 连续模 compound die复合模 punched hole冲孔 panel board镶块 to cutedges=side cut=side scrap切边 to bending折弯 to pull, to stretch拉伸 line

一、入水:gate 进入位: gate location 水口形式:gate type 大水口:edge gate 细水口: pin-point gate 水口大小:gate size 转水口: switching runner/gate 唧嘴口径: sprue diameter 二、流道: runner 热流道: hot runner,hot manifold 热嘴冷

中文 英文 机工,机器加工 machining,machine work O环,O形封垫 O ring 下料模,切料模 blanking die 寸进,寸动 inching 工程塑胶 engineering plastics 工模,夹具,支架 jig 干胶,粘著剂,动物胶 glue 干燥时间 drying time 干燥剂 drier dryer

模具英语术语是mould,不是mold,也不是tool,tool指的是工具.例句:铸造车间的模具是在工具间生产的. The moulds for the foundry are made in the tool-room area.

DRAW拉伸 TRIM, SEPARATE 切边,分离 RESTRIKE整形 PIERCE, CAM PIERCE冲孔,侧冲孔

工程部 / Design department:1) Designer - 设计师.2) Assembly drawing - 模具组装图.3) Mold layout - 模具结构图.4) 2D product drawing - 2D产品图.5) 3D product data - 3D产品数据.6) Part drawing - 散件图.7) Insert molding - 镶件模.8)

网站首页 | 网站地图
All rights reserved Powered by www.rprt.net
copyright ©right 2010-2021。
内容来自网络,如有侵犯请联系客服。zhit325@qq.com